Follett 230V 50Hz 설치 및 서비스 매뉴얼 - 페이지 14

{카테고리_이름} Follett 230V 50Hz에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett 230V 50Hz 20 페이지. 230v 50hz ice and water dispensers

페이지 인쇄

Before calling for service

1. Check that there is ice in dispenser and that congealed cubes are not causing a jam.

2. Check that circuit breaker and switches are in "ON" position.

3. Check that drain pan, rear lid and top are on securely. If ajar, dispenser will not operate. When the top is off,

auger does not operate, even though the solenoids do.

4. Check that all drains are clear.

Note: For units equipped with Follett compressed nugget icemaker, see Icemaker Operation and Service

Manual for service and troubleshooting information.

Symptom

Ice does not dispense.

• Auger motor does not run

• Wheel motor does not run

Ice does not dispense.

• Auger motor runs

• Wheel motor runs

• Gate does not open

Ice does not dispense.

• Auger motor does not run

• Wheel motor runs

Ice does not dispense.

• Auger motor runs

• Wheel motor does not run

No ice in dispenser.

If problems persist after following this basic troubleshooting guide, call Follett's

technical service department at (610) 252-7301.

Dispenser troubleshooting guide

Possible cause

1. Power switch faulty or in OFF

position; loose connection.

2. Faulty dispense switch.

3. Faulty transformer.

4. Drain pan ajar.

5. Faulty drain pan safety switch.

1. Loose electrical connection.

2. Linkage problem between

solenoid and gate.

3. Faulty solenoid.

1. Loose electrical connection.

2. Faulty auger motor.

3. Faulty run capacitor.

1. Loose electrical connection.

2. Faulty wheel motor.

3. Faulty run capacitor.

1. Power switch in OFF position or

faulty.

2. Bin signal switches in OFF

position or faulty.

3. Faulty bin t-stat.

4. Faulty transformer.

5. Icemaker related problem.

6. Faulty run capacitor.

1. Turn power switch to ON position;

check connections.

2. Replace switch.

3. Replace transformer.

4. Check pan and reseat.

5. Replace switch.

1. Check connections.

2. Check linkage.

3. Replace solenoid.

1. Check connections.

2. Check auger motor.

3. Check run capacitor.

1. Check connections.

2. Check wheel motor.

3. Check capacitor.

1. Check switch and replace if

necessary.

2. Check switch and replace if

necessary.

3. Replace bin t-stat.

4. Replace transformer.

5. Refer to icemaker Operation and

Service Manual for diagnosing.

6. Check for power and bin signal on

icemaker PC board.

Solution