Ampler Curt 사용자 설명서 - 페이지 4

{카테고리_이름} Ampler Curt에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ampler Curt 16 페이지. 2019

4/16

Insert the pedals

6 mm

V1.1, 24.04.19

Assembly

3. Take the 4 mm hex key and carefully tighten the

same stem bolts you loosened 2 steps back.

Turn your handlebar left and right and make sure it

spins freely. If it feels a bit too tight, loosen the

stem bolts and just slightly loosen the top cap.

4 mm

1. Unwrap the pedals. The pedals are marked with R

(right) or L (left). The R pedal goes on the chain-

wheel side and the L pedal goes on the non-chain-

wheel side.

2. Tighten the pedals with the 6 mm hex key Pedals

need to be tight so make sure you put some

Pedals need to be tight so make sure you put some

force into it. Expect resistance only at the end of the

thread, if the pedal is hard to thread in from the be-

ginning then the threads must be inspected.