Ampler Pennon 사용자 설명서 - 페이지 4

{카테고리_이름} Ampler Pennon에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ampler Pennon 16 페이지. 2017

4/16

Pedals

6 mm

Install front basket

V1.1, 24.04.19

Assembly

and right and make sure they spin freely. If it feels a

bit too tight then loosen the stem bolts and just

slightly loosen the top cap. Tighten the stem bolts

once again and make sure it feels good.

Unwrap the pedals which you will find in the smaller

cardboard box. You can see a 6mm hex wrench insert

in the pedal axle. The pedals will have a R and L sti-

cker/ marking on the pedal axle. This corresponds to

the side the pedal will go to. The R pedal goes on the

chainwheel side and the L pedal goes on the

non-chainwheel side. By using the hex key tighten the

pedals by turning the hex key clockwise (facing to-

wards the bike on the right side) for the right side and

counter clockwise (facing towards the bike on the left

side) for the left side. Pedals need to be tight so make

sure you put some force into it.

Note: this only applies if a front basket is included in

the order. Your order should arrive in 2 parcels. One

will include the bike and the basket will be in a sepa-

rate one. Attaching it is easy as we have pre-assem-

bled the hardware and you will just need to attach

the basket itself.

1. Unwrap the basket from the cardboard box.

2. Take the 4 mm hex key and unscrew the nuts on

the basket attachment plate. 3. Unscrew the bot-

tom basket attachment plate located on the bottom

side of the basket.

3. Note: this only applies if the light set is also ordered.

4. Attach the front light mount between the baskets

underside and the bottom attaching plate. Plug in

the light socket.

5. Tighten the 4 bolts and make sure your basket sits

secure.