Follett HCC1410ABT 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Follett HCC1410ABT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett HCC1410ABT 8 페이지. Self-contained chewblet ice machine

페이지 인쇄

4 – Horizon Elite ice machine mounting accessories

Optional wall mount bracket

30.50"

(77.7 cm)

5 – Horizon Elite drains - specifier guidelines

Ice machine drain plumbing

silicone tubing

3/4" barb x 3/4" FPT

➋

➌

1" standpipe/drain

Chassis drain plumbing – Required

Self-contained 1010, 1410 series ice machine

Optional machine stand

22.00"

(55.9 cm)

25.50"

(64.8 cm)

➊

Minimum 8"

radius

2 ft x 1" OD

3/4" MPT x 1" slip

6.88"

(17.50 cm)

13.00"

(33.0 cm)

A - 25.2" (64.0 cm)

B - 28.7" (72.9 cm)

Important specifier notes

1. For secure wall mounting, specify

optional wall mount bracket.

2. Wall and fasteners must support the

weight of the ice machine, bracket,

supply water and ice. Use of a backing

board may be required with hollow wall

construction.

3. Machine stand mounting adds 6.88"

(17.5 cm) to height of ice machine.

4. No dips in tube routing allowed.

5. Ice transport tube needs minimum

1/4" per foot (2 cm per meter) pitch

toward ice machine and should be

secured to prevent dips and traps

from forming.

21.00"

(53.3 cm)

Important specifier notes: Where code

allows, follow recommendation below.

1. Apply Teflon tape to 3/4" male outlet ice machine

fitting. Thread on either the provided straight

3/4" barb adapter or a 90 degree adaptor.

Connect the supplied 2' (0.61 m) silicone hose to

➊

the 3/4" drain barb

2. It is recommended that the silicone hose be

routed down into a 1.5" or 2" standpipe/drain.

The minimum drain size for the ice machine is 1".

Note: 3/4" to 1" PVC adapter fittings are provided

if a larger drain size is not possible

Note: Minimum 8" radius on silicone drain line.

Drain line from the ice machine must have at least

1/4" per foot pitch (6.4 mm/0.3 m).

Note: Standpipe/drain provided by others. All

other components provided with ice machine.

Important specifier notes: Where code

allows, follow recommendation below.

11. Remove white 3/8" plug from rear push‑in fitting

➊

2. Route 3/8" OD drain tubing (preferably copper)

through rear of docking station and fully insert

into chassis base push‑in fitting. Route into drain

standpipe.

3. Gravity drain. Ensure 3/8" OD tubing slopes down

into drain standpipe without forming a trap.

➋ ➌

Form# 7030