Follett HCD710ABS 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Follett HCD710ABS에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett HCD710ABS 8 페이지. Ice storage bins
Follett HCD710ABS에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (17 페이지)
페이지 인쇄
4 – Horizon Elite ice machine mounting accessories
Optional wall mount bracket
23.00"
(58.4 cm)
5 – Horizon Elite drain - specifier guidelines
Flush drain plumbing – For regular machine drainage
➊
Minimum 8"
radius
2 ft x 1" OD
silicone tubing
3/4" barb x 3/4" FPT
➋
3/4" MPT x 1" slip
➌
1" Stand pipe/drain
Chassis drain plumbing – To assist with condensate in high humidity areas
Self-contained 710 series ice machine
Optional machine stand
22.00"
(55.9 cm)
(47.5 cm)
25.50"
(64.8 cm)
22.25"
(56.5 cm)
6.88"
(17.48 cm)
18.70"
13.00"
(33.0 cm)
(41.9 cm)
Important specifier notes
1. For secure wall mounting, specify
optional wall mount bracket.
2. Wall and fasteners must support the
weight of the ice machine, bracket,
supply water and ice. Use of a backing
board may be required with hollow
wall construction.
3. Machine stand mounting adds 6.88"
(17.5 cm) to height of ice machine.
4. No dips in tube routing allowed.
5. Ice transport tube needs minimum 1/4"
per foot (2 cm per meter) pitch toward
ice machine and should be secured to
prevent dips and traps from forming.
16.50"
Important specifier notes: Where code
allows, follow recommendation below.
1. Connect the silicone tubing to the ice machine
3/4" drain barb
➊
.
2. Assemble the 3/4" barb x 3/4" FPT to the 3/4"
MPT x 1" slip. Connect the other end of the
silicone tubing to the 3/4" barb
3. Connect the 1" slip fitting to the 1" stand pipe/
➌
drain
.
Note: Minimum 8" radius on silicone drain line.
Drain line from the ice machine must have at least
1/4" per foot pitch (6.4 mm/0.3 m).
Note: Stand pipe/drain provided by others. All
other components provided with ice machine.
Important specifier notes: Where code
allows, follow recommendation below.
1. Plug must be removed from John Guest fitting.
2. Route 3/8" drain tubing through knockout in back
of docking station and insert fully into John Guest
fitting connection at the rear of the machine
chassis. Route other end of 3/8" drain tubing
to drain.
3. Drain must slope 1/4" inch per foot
(6 mm per 30.4 cm).
➋
.
7
Form# 8225