COMBISAFE 9530 사용자 지침 - 페이지 2

{카테고리_이름} COMBISAFE 9530에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. COMBISAFE 9530 2 페이지. Barrier box
COMBISAFE 9530에 대해서도 마찬가지입니다: 사용자 지침 (4 페이지)

페이지 인쇄
COMBISAFE 9530 사용자 지침
COMBISAFE
!
Max
1020 kg
Max
60°
© Combisafe International AB 0208
Subject to technical changes
®
0208-012
ID number
COMBISAFE
®
Batch
9530
Max
1020 kg
Max
60°
0208-012
Year Month Serial Number
1
2
1
!
2
1
2
Always read the instruction manual before use
Combisafe accepts no liability for items that has
been altered
Use
- Only use the Barrier box for it’s intented purpose
only, don’t stack or load anyting other than
Combisafe Steel mesh barriers No. 3200
- Load box with maximum 50 barriers
- Secure nets in box from sliding or overturning.
Use strap around box and barriers
Lifting by crane
- Use a suitable 4-legged lifting chain with
permissable loadability (SWL) above 1020 kg.
- Max chain spread angle 60°
Lifting with forks
- The box can be lifted from all sides with forks.
When lifting from short side, make sure that
the barriers ins’t in the way.
- Place forks centered on box and make sure
that forks is pushed in enough so the box
supports on both sides.
COMBISAFE
1
2
1
Don’t stack
beyond this
2
point
1
2
800 mm
1130 mm
1142 mm
®
Stacking nets in the box
It’s importent to stack the nets correctly in the box.
Otherwise the nets will become too high and
unstable.
Place every second net in opposite direction, i.e
every second net with the toebord upwards.
Make sure that the nets are placed centrally in the
box to avoid overturning.
Don’t stack nets above the beam
The nets weigh 19,5 kg and can be handled by one
person, but it is recommended for frequent loading
and unloading to be carried out by two persons or
use lifting equipment. Don’t move or lift the box by
hand
Refer to current Health and safety regulations
applicable to contry of use to ensure compliance.
Safety precaution
Before every use
Always check the Barrier boxes for any signs of
damage or visible deformation.
Don’t use boxes that don’t pass checks according
to the following checklist:
Checklist
- Crack free and notch-free welds
- Deformation
- Corrosion
- Damage
- Wearing
- Visible Combisafe label and ID number
- Deformed or damaged lifting eyes
- No sharp edges
If in doubt consult Combisafe!
Annual Inspection
It is recommended that the box is inspected at least
once a year by a trained competent person unless
stated otherwise in a community country of use.