Follett Horizon Elite 2110 Series 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Follett Horizon Elite 2110 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Horizon Elite 2110 Series 17 페이지. Ice machine models with ride technology
Follett Horizon Elite 2110 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (8 페이지)
페이지 인쇄
Prepare the dispenser.
2.1
3.1
Dispenser preparation
4"
(101,6mm)
• Determine best route for ice transport tube run. Note: 12" (304,8mm) clearance is required.
• Drill 1 3/4" (44,5mm) hole through either side of dispenser
• Install gasket
➋
onto bulkhead fitting
• Attach bulkhead fitting with flat up
• Position and secure nut locking plate
• Verify installation of O-ring on stainless steel ice transport tube coupling
• Insert stainless steel ice transport tube coupling
cap
➑
• Heat end of transport tube in cup of 160 F (71 C) hot water to soften and spread with pliers
before making connection to ease assembly
• Attach ice transport tube to coupling with supplied hose clamp
6
➌
➍
and tighten bulkhead nut
➏
with supplied screws
➐
into bulkhead fitting and secure with coupling
remote condensing
Dispenser preparation
Hot Water
160 F (71 C)
12"
(304,8mm)
min.
➊
➎
➐
➓
DROP-IN • RIDE Technology
3
➒