CombiSteel 7950.0100 사용자 설명서 - 페이지 5

{카테고리_이름} CombiSteel 7950.0100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CombiSteel 7950.0100 15 페이지. Saladettes

Start-up of the saladette

Before use, we recommend that the saladette is cleaned, see the section on maintenance and cleaning.

Important !

If the saladette has been vertically placed during transport, please wait 2 hours before starting up the saladette.

Connect the saladette to a socket and turn on the switch on the control panel, see fig. 1.9.

The thermostat is placed in the control panel, see fig. 2.0.

The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.

When turning on the saladette the display will show the current temperature in the saladette.

Display set temperature:

Press this key and the display will show the set temperature. Press the key again to return to normal

reading

Set new temperature:

Press this key continuously for more than 3 seconds and the display shows the set temperature.

Press this key to increase the set temperature.

Press this key to lower the set temperature.

Press this key to save the new settings. The display will flash with the new value and will then return

to normal reading.

Alarm codes:

'P1' Flashing in the display: indicates that the saladette sensor is defective.

The saladette will strive to keep the set temperature until it has been repaired.

Fig 1.9

Fig. 2.0