Caraudio-Systems c.LOGiC lite C1-C25 매뉴얼 - 페이지 5
{카테고리_이름} Caraudio-Systems c.LOGiC lite C1-C25에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caraudio-Systems c.LOGiC lite C1-C25 11 페이지. For navigation systems mercedes benz comand 2.5
페이지 인쇄
3. Installation
Switch off ignition and disconnect the vehicle's battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
3.1.
Connections to the Comand
Place of installation is behind the Comand. Remove the head-unit from the dash-board.
If female 8pin C1 connector of factory harness exists, transfer pins from female 8pin
C1 connector of C1C-MB25 to corresponding slots of female 8pin C1 connector of
factory harness. If slots are occupied remove and isolate factory wires (take notes
before removing).
Otherwise use female 8pin C1 connector of C1C-MB25 instead of factory connector.
Connect yellow loose wire (CAN high) C1C-MB25
to pin 18 of chamber C2. Connect loose blue wire
(CAN low) of C1C-MB25 to pin 17 of chamber C2.
Connect loose red wire of C1C-MB25 to pin 4
of chamber A (+12V battery power).
Connect loose black wire of C1C-MB25 to pin 8
of chamber A (ground).
Plug female 8pin C1 connector of factory harness
(if not existing, of C1C-MB25) into C1 slot of
Comand's male system connector.
Plug male 5pin DIN connector of harness C1C-MB25 into female 5pin DIN socket on
the Comand's rear.
Version 01.09.2011
B
A
4
17 18
8
C1-C25