Caraudio-Systems TV-Free TF-NTG5 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Caraudio-Systems TV-Free TF-NTG5에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caraudio-Systems TV-Free TF-NTG5 5 페이지. Video-in-motion interface

페이지 인쇄

Pin-assignment of the CAN-Box TV-500 (Molex 8pin)

Cable colour

Pin-No. Assignment

●

Yellow

Pin 4

●

Blue

Pin 3

●● Yellow/Black Pin 8

●● Blue/Black

Pin 7

●

Red

Pin 1

●

Black

Pin 5

●

Green

Pin 6

●

White

Pin 2

2. Installation

Switch off ignition and disconnect the vehicle's battery! If according to factory rules

disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is

sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a

resistor lead.

S-Class: Place of installation is at the head-unit, this is behind the flap below the control

unit. Monitor and the control unit must NOT be removed!

The centre console must be loosened in S-Class (W222) and pushed back. In luxury models

with separate rear seats the centre console is continuous and the rear seats must be

removed, too.

The vehicle is very responsive to disconnected vehicle parts while battery is connected.

Therefore the error memory of the vehicle must be deleted after installation.

Note: Any existing fiber optical cables on the original Quadlock plug must be reconnected to

the TV-MBN5 harness.

Version 10.03.2020

CAN-HIGH – connection to the head-unit

CAN-LOW – connection to the head-unit

CAN-HIGH – connection to the vehicle

CAN-LOW – connection to the vehicle

+12V permanent

Ground

Activation of the video-in-motion function

(+12V = TV-free activated)

Trigger output (+12V DC 500mA)

TF-NTG5