Follett Horizon Elite HCD1810NJS 설치 지침 매뉴얼 - 페이지 10
{카테고리_이름} Follett Horizon Elite HCD1810NJS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Horizon Elite HCD1810NJS 17 페이지. Ice machine models with ride technology
Follett Horizon Elite HCD1810NJS에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (8 페이지)
페이지 인쇄
Connect utilities to docking assembly.
6.1
Water and drain
➋
➏
3/4" barb x 3/4" FPT
➍
➎
1" Stand pipe/Drain
• Rough-in ice machine potable water
supply
➊
. 3/8" push-in connection will be
made at included shut-off valve then at
back of docking station into solenoid.
• Remove access panel if necessary
• Connect the silicone tubing to the ice
machine 3/4" drain barb
• Assemble the 3/4" barb x 3/4" FPT to the
3/4" MPT x 1" slip. Connect the other end
of the silicone tubing to the 3/4" barb
• Connect the 1" slip fitting to the 1" stand
pipe/drain
➎
.
Note: Minimum 8" radius on silicone
drain line. Drain line from the ice machine
must have at least 1/4" per foot pitch
(6,4mm/0,3m).
• Apply Petrogel to barbed drain fitting
• Replace access panel.
10
➊
➌
Minimum 8"
radius
2 ft. x 1" OD
silicone tubing
3/4" MPT x 1" slip
➋
.
➌
.
➍
.
➏
External connections
Chassis drain plumbing - required
• Plug must be removed from John Guest
fitting.
• Route 3/8" drain tubing through knockout
in back of docking station and insert fully
into John Guest fitting connection at the
rear of the machine chassis. Route other
end of 3/8" drain tubing to drain.
• Drain must slope 1/4" inch per foot (6 mm
per 30,4 cm).
6.2
Refrigerant
➊
• Braze supplied quick-connect lines onto
stub-ins
remote condensing
➊
.
DROP-IN • RIDE Technology
6