Downeaster 3042 사용 설명서 - 페이지 2

{카테고리_이름} Downeaster 3042에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Downeaster 3042 2 페이지. Indoor/outdoor min/max temperature medallion & classic series

Indoor/Outdoor Temperature

With Minimum/Maximum Function

-Medallion & Classic Series-

TO INSTALL:

Using the screw provided, install the temperature sensor outside on the

NORTH side of the house where it will be out of the sun, a minimum of 4'

above the ground, and away from any heat sources such as louvers, vents,

etc. DO NOT cut the wire length of the sensor, as it is calibrated for all 50

feet; keep any leftover wire coiled up and out of the way.

DO NOT PLUG IN THE INSTRUMENT UNTIL ALL OTHER CONNECTIONS

HAVE BEEN MADE!

1 – Run the wire from the outdoor sensor inside to the back of the dial

and connect the 3 colored wires to the corresponding colored terminals at

the TOP of the dial.

2 - Connect the AC power supply wires to the bottom terminals (either

wire to either terminal: there is no polarity).

3 - (Optional Step) Attach a new 9Volt battery to the connector attached

to the middle terminals. This will run the instrument for a couple of days

should the power go out.

TO OPERATE:

The RIGHT push button (as viewed from the front) switches from

Indoor to Outdoor readings. The LEFT push button switches

between High, Low, and Actual (i.e., current) temperature readings.

To read the current Outdoor temperature, push the Right button

momentarily until the light marked "Outdoor" is lit. Then push the

Left button momentarily until the light marked "Actual" is lit. The

pointer will now indicate the current outdoor temperature. Push

the Left button again to read the Outdoor/Low, then push the Left

button again to read the Outdoor/High. One more push will return

to the current reading.

For Indoor readings, push the Right button once to activate the

"Indoor" light. Then repeat the procedures above to cycle between

High, Low, and Actual (current) readings.

To clear either the High or Low memory, cycle to the indication you

wish to reset and hold the Left button in for 4-5 seconds until the

red light blinks, indicating that the memory has been cleared.

BOX CONTENTS:

1 - Temperature Dial

1 - Temperature sensor and housing with 50' of wire

1 - 6Volt AC power supply plug

Please call with any questions regarding installation or

operation of this instrument.