Dahua DH-LR2226-24ET-360 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} Dahua DH-LR2226-24ET-360에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua DH-LR2226-24ET-360 16 페이지. 16/24-port epoe switch

Grounding the Device can protect it against lightning and interference.

Step 1

Remove the ground screw from the Device and pass the ground screw through the round

hole of the OT terminal of the ground cable. Turn the ground screw clockwise with a cross

screwdriver to fasten the OT terminal of the ground cable.

Step 2

Wind the other end of the ground cable into a circle with the needle-nose pliers.

Step 3

Connect the other end of the ground cable to the ground bar, then turn the hex nut

clockwise with a wrench to fasten the other end of the ground cable to the ground

terminal.

Before connecting the power cord, make sure that the Device is securely grounded.

Step 1

Connect one end of the power cord to the power jack of the Device.

Step 2

Connect the other end of the power cord to the external power socket.

The Ethernet port is a standard RJ-45 port. With its self-adaptation function, it can be automatically

configured to full duplex/half-duplex operation mode. It supports MDI/MDI-X self-recognition of the

cable, allowing you to use a cross-over cable or straight-through cable to connect the terminal

device to the network device.

4 Wiring

Figure 4-1 Connect GND

Figure 4-2 Ethernet port pin number