Dahua DH-PFS4226-24GT-360 빠른 시작 매뉴얼 - 페이지 15

{카테고리_이름} Dahua DH-PFS4226-24GT-360에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua DH-PFS4226-24GT-360 19 페이지. 16/24-port poe gigabit managed switch

페이지 인쇄

We will introduce VLAN configuration briefly in this section. See the corresponding command

line manual for detailed configuration.

4.1

First Login by Console Port

method to configure other ways to log in the device.

Step 1

Power off the PC.

Step 2

Connect the PC and the device with the default console port cable. Insert the DB-9

(hole) plug of console port cable into the 9-pin serial port of PC, and then insert the

RJ-45 plug into the console port of the device.



Check the mark on the port before you insert the plug and make sure you insert

the plug into the correct port.

Plug out RJ-45 first and then DB-9 when dismantling console port cable.



Step 3

Power on the PC.

Step 4

Run terminal simulation program on the PC. Select the serial port connected with the

device, and configure the terminal communication parameters. The parameter values

should match with the values of the device. By default:



Baud rate:115200



Data bit: 8



Stop bit: 1



Parity: none



Flow control: none

If the PC adopts Windows Server 2003 operating system, add the super terminal

program in the Windows component and then login and manage the device according

to this Guide. If the PC adopts Windows Server 2008, Windows Vista, Windows 7, or

other operating systems, use the third-party terminal control software and refer to the

software operation guide or online help for operation method.

Step 5

Power on the device, and the device self-check information is displayed on the terminal.

There will be the prompt for you to press Enter key after device self-check. And you can

enter the user name and password.

Step 6

Enter the user name, and then press Enter key.

Figure 4-1

Connection with console port cable

Quick Operation

Quick Operation 9