Dahua PFS3005-4ET-60-V2 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Dahua PFS3005-4ET-60-V2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua PFS3005-4ET-60-V2 13 페이지. Ethernet switch (4/8-port unmanaged desktop switch)

페이지 인쇄

4.1 Connecting GND

Normal GND connection of the device is the important guarantee for device lightning protection

and anti-interference. The steps for connecting the GND are as follows:

Step 1

Remove the ground screw on the device and place it properly. Pass the ground screw

through the round hole of the OT terminal of the ground cable. Turn the ground screw

clockwise with a cross screwdriver to fasten the OT terminal of the ground cable.

Step 2

Wind the other end of the ground cable into a circle with needle-nose pliers.

Step 3

Connect the other end of the ground cable to the ground bar, turn the hex nut clockwise

with a wrench to fasten the other end of the ground cable to the ground terminal.

4.2 Connecting Power Cord

Before connecting the power cord, make sure that the device is reliably grounded.

Step 1

Connect one end of the power cord into the power jack of the device accurately.

Step 2

Connect the other end of the power cord to the external power socket.

4.3 Connecting Ethernet Port

Ethernet port adopts standard RJ-45 port. With self-adaptation function, it can be automatically

configured to full duplex/half-duplex operation mode. It supports MDI/MDI-X self-recognition of the

cable, therefore, you can use cross-over cable or straight-through cable to connect terminal device

to network device.

4 Wiring

Figure 4-1 Connect GND