Advanced Mxp-536 매뉴얼 - 페이지 11

{카테고리_이름} Advanced Mxp-536에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Mxp-536 16 페이지. Peripheral zone card

3 Card Configuration Setup

Expand the Panel (in the "Site List") and select the "Peripheral Bus" node; this will bring up a list of available

cards that can be connected to the peripheral bus in the "Device Selector".

Unlike most peripheral devices the PC1124 is represented twice in the "Device Selector"...

Select the desired operation mode (Class A / B) and add it to the design.

The device should be added to the same address as the one set on the card.

The selected operation mode should match the mode set on the card; failure to do so will result in a

type change error being reported against that card, after upload.

Output configuration is performed along the same line as any other output device/point.

If the card is operating in "stand-alone" mode (but still present in the design, and connected to the

peripheral bus) these output settings will have no effect on the relay behaviour.