CombiSteel 7489.4 Series 사용자 설명서 - 페이지 7

{카테고리_이름} CombiSteel 7489.4 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CombiSteel 7489.4 Series 11 페이지. Ice cube machines

Assembly of Ice Maker

Place Selection for Your Product

Your product should not be in direct contact with heat sources and should not be placed close to the heat

sources.



If you will place electrical equipments (which may be a heat sources) on the side surfaces of the product,

you should leave at least 10 cm of distance.



If the product is to be placed nearby the wall, the distance between the back surface of the product and the

wall should not be less than 20 cm. (see Figure 7)



Do not place objects in front of the ventilation filter that might prevent air intake to the product. Do not

place your product outdoor. This product is designed for use indoors.

Electric Connection



Mains voltage and frequency values have to be at the voltage and frequency values written on the product.

If you need assistance in this regard, please contact nearest Frozy Authorized Service or seek support from

qualified electricians.

Make sure that your grid has a grounding unit. The fuse value of the socket to which the product will be

plugged should be 10A.

Do not use multi sockets or extension cords to start your product.

Water Use and Connection

Frozy Ice Maker is designed for you to make ice in the most ideal time and size. However, note that there are

some criteria that will affect the quality of the ice as well as the lives of the components included in the Ice Maker.

These criteria are;

As for the Mains Water;

Being in a drinkable quality,

Having optimum hardness degrees,

Having minimum amount of chlorine.

The optimum water filters chosen for your product are available at your Frozy Authorized Service.

Min. Water temperature 10°C – Max. Water temperature 30°C – Max.

Installation

Remove and disassemble all packaging materials of the product before installation.

The ice wire, waterproofing plastics and the ice scoop are provided for your valuable customers inside the

product. If any part or accessory is missing, please contact our customer services.

Clean the inner body with warm water and a soft cloth before using the ice maker.

Clean the ice trays with warm soapy water. Dry with a soft, cotton cloth. After placing the ice maker at the

assembly point, wait 2 (two) hours before operating to get the cooling system pressure stabilized.

Install the parts inside the ice maker in accordance with the assembly instructions.