Follett Maestro Chewblet 400 Series 설치, 운영 및 서비스 매뉴얼 - 페이지 13
{카테고리_이름} Follett Maestro Chewblet 400 Series에 대한 설치, 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Maestro Chewblet 400 Series 20 페이지. Ice machine and top kit
Follett Maestro Chewblet 400 Series에 대해서도 마찬가지입니다: 설치 및 서비스 매뉴얼 (20 페이지), 설치 및 서비스 매뉴얼 (20 페이지)
페이지 인쇄
23. Connect the ice transport tube(s) to the dispenser:
a) Drill 3/16" (5mm) holes through both sides of the tube
1/2" (13mm) from the tube end.
b) Collapse tube and insert through gasketed hole (Fig. 7).
c) Match tube holes to bracket tabs.
24. Route bin thermostat capillary tube from the 4" x 4"
(102mm x 102mm) junction box into bin alongside the ice
transport tube. Secure capillary tube into bracket (Fig. 7).
25. Reinstall the dispenser cover with supplied screws (Fig. 13).
26. Install telescoping chase (RIDE model ice machines only).
a) Mount lower chase section to chase bracket on counter
with supplied screws (Fig. 14.1).
b) Position upper chase section over lower chase section.
Align top of upper section to top of stainless dispenser top
(Fig. 14.2).
c) Drill pilot holes on both sides of chase and secure with
supplied screws (Fig. 14.3).
27. Turn ice machine power and water on.
28. After ice machine has made ice for approximately 15 minutes
complete the following start-up checks:
a) Dispense ice.
b) Hold ice on bin thermostat and make sure
ice machine shuts off.
c) Remove ice from bin thermostat and make sure
ice machine restarts.
Note: Ice machine has a 20 minute restart delay.
Fig. 13
Fig. 14
Maestro 400 Series Top Kit for Lancer
2
3
3
1
1
1
13