Amplitec C23S Series 사용자 설명서 - 페이지 11

{카테고리_이름} Amplitec C23S Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amplitec C23S Series 13 페이지. Dual band repeater
Amplitec C23S Series에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)

페이지 인쇄

3) Put the expansion plug(size: 8mm) into the 4 drilled holes.

4) As shown in the figure, align the fixing holes of the U-shaped back holder with corresponding

holes on the wall. Then drive 4 pcs of M6*40 screws into the expand plugs with screwdriver. Finally,

hang the repeater firmly on the U-shaped back holder.

Antenna Connection

Choose suitable outdoor and indoor antennas according to the characteristic of the coverage

area. Installation and connection of the antennas should follow the requirements as following:

1) The outdoor antenna should be installed at the place with the strongest signal and aiming

towards BTS.

2) The length of the cable, which connects the outdoor antenna and the repeater, should be less

than 20 meters.

3) Wrap the waterproof tape around the connection part of the outdoor antenna and outdoor

cable, keeping it away from water oxidation and corrosion.

4) The height difference between the indoor and outdoor antennas should be over 5m, and the

transmit direction of indoor antenna should not aim at the outdoor antenna.

5) It will be better if there is a wall between outdoor and indoor antennas.

6) Outdoor antenna should connect to BTS port of the repeater, while indoor antenna to the MS

port.