1byone 102US-0002 사용 설명서 - 페이지 3

{카테고리_이름} 1byone 102US-0002에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 1byone 102US-0002 5 페이지.

페이지 인쇄

Safety note:

• Weak batteries for the receiver can greatly reduce the

ringtone volume, please change the same voltage and

type batteries every 8-10 months.

• Weak battery for the push button can reduce the

operating distance. If the performance of the push button

deteriorates or completely stops, please replace with

another 3V type CR2032 battery.

• Always insert the battery using the correct polarity to

eliminate the danger of fire.

• Keep old and new batteries away from children.

• Old batteries should be properly disposed using safe

environmental practices.

• Remove the batteries from the receiver and push button if

the doorbell system is not to be used for an extended

period of time.

4. Operation:

A. Selecting the notification mode:

The doorbell receiver can notify after the push button has

been pressed by playing a ringing sound, flashing an LED,

or ringing and flashing an LED at the same time. These are

referred to as Sound, Flash, and Sound+ Flash mode.

When the Sound and flash button

receiver will play a "beep" sound signifying Sound Only

mode; flash a LED signifying Flash Only mode; play a "beep"

sound and flash a LED at the same time signifying Sound +

Flash mode. Press the Sound and flash button until you

reach your preferred notification mode.

B. Selecting the ringtone:

There are 36 programmable ringtones for selection.

MODE

is pressed, the

Press the ringtone selector button

ringtone. Stop pressing this button when you have reached

the desired ringtone.

C. Adjusting ringtone volume:

Press the volume button

set. There are 6 volume levels for selection.

D. Re-pairing Function:

If a receiver starts ringing even when the push button isn't

pressed, or a push button interferes with other receivers, it

may be necessary to reset the current pairings and pair

again.

To reset the push button:

Press the Paring button on the receiver and hold for 5

seconds. The LED light will come on and beep five times

then all pairing information for the push button(s) will be

deleted. Next, unplug or remove the batteries from the

receiver and then reattach it to power after 30 seconds. The

LED light will come on for 15 seconds and beep once. This

means the receiver is in pairing mode. Next press the push

button. If pairing is successful, the receiver should ring. It

normally takes about 10-15 seconds for the push button

and receiver to pair. If there is no pairing within 15 seconds,

the LED will turn off and beep twice and automatically exit

pairing mode. Please try pairing again.

to change the

VOL

until the desired volume is