AmpliVox S230A 사용자 설명서

{카테고리_이름} AmpliVox S230A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AmpliVox S230A 2 페이지. Voice carrier portable public address system
AmpliVox S230A에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄

INCLUDES:

•

Wheeled Carrying case

•

New S805A/SW805A Multimedia Stereo Amplifier

•

Professional Cardioid Microphone

•

Gooseneck Mic holder with Tripod floor stand

•

Two Speakers with Tripod Stands

SET UP:

INSTALL POWER SUPPLY

Battery pack is standard.

International AC Adapter/Recharger (110/220V, 50/60Hz). Model S1462, 12 Volt DC adapter

(automotive cigarette lighter plug-in). Model S1465, NiCad Battery Pack.

TO INSTALL OR REPLACE BATTERIES

Remove all plugs from amplifier. Slip a fingernail under battery door, and slide it out. Lift out

battery holder from amplifier. Insert 10 new Alkaline "D" cell batteries. Be careful to observe

polarity. Carefully replace battery pack. Replace battery door.

Do not mix battery types or attempt to recharge alkaline batteries – equipment damage, safety

hazard or fire could result.

TO OPERATE:

Plug microphone into DYNAMIC Microphone jack.

Plug speaker leads into SPEAKER jacks. Turn Amplifier on (switch is located on the front of the

amplifier). The red light will go on, showing that power is available. Rotate VOLUME control

knob to obtain desired loudness level throughout the coverage area.

ON-OFF

When switch is in the ON position, the red light will be on.

DC IN

Connection for optional adapters:

•

S1460 International AC Adapter/Recharger

•

S1462 12 Volt DC (automotive cigarette lighter) Adapter

AUX OUT

Connection for 12 to 15V DC accessory

VOLUME

Rotate clockwise to increase amplification.

MICROPHONE INPUTS

VOICE CARRIER

PORTABLE PUBLIC ADDRESS SYSTEM

MODEL S230A/SW230A

Alternate Power Supplies may be substituted.

Model S1460,