AmpliVox S505 사용자 설명서 - 페이지 2

{카테고리_이름} AmpliVox S505에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AmpliVox S505 4 페이지. Executive column sound lectern
AmpliVox S505에 대해서도 마찬가지입니다: 사용자 설명서 (4 페이지)

페이지 인쇄

NO TOOL ASSEMBLY OF LECTERN

Please read all instructions first and then follow the steps below.

Your lectern may not contain all of these features.

BASE ASSEMBLY

1. Remove center column from

the shipping carton and place

as shipped (speakers face

down) on the floor or on a suit-

able sturdy table. If assembling on

floor, raise bottom end of lectern to

make fastening base to lectern

easier.

2. Remove and unpack the base

from the shipping carton.

3. Position base with the two locking

wheels facing the back of the lec-

tern. Assemble the base to the

column by using four of the 2 inch

long knurl knob screws supplied

with the lectern.

TIP: Do not completely tighten

each screw as you place it through

the base and into the column. Wait

until all four screws have been put

into the proper position and then

tighten them up.

4. Turn the base and column assem-

bly upright. If assembled on a ta-

ble, place the unit upright on the

floor.

READING TABLE ASSEMBLY

1. Remove and unpack the lectern

reading table.

2. Attach the table to the top of the

column. This is accomplished by

placing the table top on the col-

umn base and lining up the cor-

ners.

TIP: the corners need to be lined

up in order to get the screws in the

table top.

3. Fasten the reading table to the

column with the 4 - 1 inch long

knurl knob screws supplied. The

knob screw goes up into the read-

ing table through the 4 holes in the

column

MOUNTING FLANGE

READING TABLE

CENTER COLUMN

AMPLIFIER

BASE

SPEAKER GRILLE

Remove and unpack the speaker grille..

Attach the speaker grille to the front of

the lectern by pushing the plastic posts in

each corner of the grille into the 4 cups.

ASSEMBLY OF FLEXIBLE GOOSENEC MICROPHONE

The MIC CORD comes pre-wired to the am-

plifier but needs to be assembled into the

MOUNTING FLANGE located in the far left

corner of the READING TABLE .

Take the plug end of the microphone cable

and insert into the rubber boot of the

MOUNTING FLANGE from underneath.

Push plug end all the way through the

rubber boot.

Now take GOOSENECK MICRO-

PHONE and connect to the plug end of

the cable. Notice that the microphone

connector has three small (3) pins in-

side of the connector. These pins can

bend if you are not careful. Align these

pins with the three (3) holes in the plug

end of the cable and push together until

microphone is completely seated onto the

plug.

Now carefully take excess cable and push

back through rubber booth first, then insert

the microphone only far enough that it is

able to stand upright without falling over.

FLEXIBLE GOOSENECK

MICROPHONE

ONTROL PANEL