AmpliVox AMP-W450 쉬운 단계별 지침 - 페이지 2

{카테고리_이름} AmpliVox AMP-W450에 대한 쉬운 단계별 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AmpliVox AMP-W450 2 페이지. Presidential plus lectern assembly featuring quickfit-expando 6 connectors

페이지 인쇄

figure 2

4. Attach front panel to left side. With the

left side panel laying on the work surface,

attach the front panel by sliding the connectors

over the steel pins. Both bottom unfinished edges

should be on the side. Use a phillips

screwdriv-

er to tighten the 3 Quickfit-Expando 6 connec-

tors. Turn 1/2 turn clockwise.

Do not overtighten the connectors. Over

tightening can break the connectors. [figure 3]

5. Install bottom panel. Push Minibloc connec-

tors in the bottom panel. Place bottom panel in

the slot on the leftsidepanel,flat unfinished edge

against the front panel. Using a phillips screw-

driver, install 4Minibloc Screwpins through the

Minibloc holes into the predrilled holes in the

side panel. [figure 4]

6. Attach right side panel. Place the right side

onto the front and bottom panel, tighten the 3

Quickfit-Expando 6 connectors in the

front panel

and install 4 Minibloc

Screwpins in the 2

Minibloc connectors on

the bottom panel.

Carefully roll unit onto

front panel.

7. Install reading table and shelf. Slide read-

ing

table over steel pins and tighten 4 Quickfit-

Expando 6 connectors. Slide shelf over steel pins

and tighten 4 Quickfit-Expando 6 connectors.

Install 2 locking casters on the finished side of

the bottom panel and 2 non-locking casters using

figure 3

figure 4