Follett EU155N Series 설치, 운영 및 서비스 매뉴얼 - 페이지 5
{카테고리_이름} Follett EU155N Series에 대한 설치, 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett EU155N Series 20 페이지. Ice and water dispensers
Follett EU155N Series에 대해서도 마찬가지입니다: 설치 및 서비스 매뉴얼 (20 페이지), 설치, 운영 및 서비스 매뉴얼 (20 페이지)
페이지 인쇄Specifi cations –––––––––––––––––––––––––––––––––––––––––––––––––––––
Electrical requirements
§ Each ice machine and dispenser requires separate circuit with electrical disconnect within 6m. Equipment
ground required.
§ 230V, 50 Hz, 2A
Plumbing
Dispenser
§ 3/4" PVC slip joint for hopper drain
§ 3/4" PVC pipe nipple for beverage drain pan
§ 3/8" ID red line tubing for water in
§ Drains should be hard piped and insulated. Maintain at least 6 mm per 304 mm (1/4" per 12 in.)run slope on
drain line run
Ice machine
§ Refer to Ice machine Installation Manual packed with ice machine for installation instructions
Clearance and access information
§ 1296mm above counter
§ 305mm on side opposite tower, below counter
§ Counter front or rear panel must be removable for service access to both sides of dispenser and ice
machine(s), if any
§ Below counter access to drain clean-out required on utility side of dispenser
§ See Ice machine Installation Manual packed with ice machine(s) for clearance requirements for automatic
load dispensers
Side view
696mm
305mm
water connection
hopper drain
661mm
153mm min
432mm
beverage
pan drain
480mm min
480mm min
305mm min
Automatic load units with 1 ice machine
Automatic load units with 2 ice machine
EU155N Ice and Water Dispensers
Front view
305mm
553mm
1264mm
712mm
794mm
5