Comcater FC54-EA 사용 설명서 - 페이지 12

{카테고리_이름} Comcater FC54-EA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Comcater FC54-EA 19 페이지.

INSTRUCTIONS FOR TECHNICAL PERSONNEL

INSTALLATION

1)During installation, carry out proper machine levelling, which is a

prerequisite for a correct operation thereof (max. tolerance 2°).

In order to prevent any damage caused by steam going out of the machine,

make sure that the surrounding materials do not deteriorate in its presence.

After machine installation check thermostat settings, booster 85°C, tank 60°C.

The electrical safety of this equipment is only assured if it is connected as

follows.

It is necessary to connect the equipment to an effective earthing as specified

by the electrical safety regulations in force. Check that this basic requirement

is complied with, in case of any doubt ask for a careful check of the

installation by a qualified personnel.

In the case the earthing is not efficient there will be a dispersion due to the

suppresser.

The machine shall be included in a correctly dimensioned equipotential, whose

effectiveness is to be very tight in accordance to the procedures set for in the

applicable safety standards. The connection shall be performed through a

screw marked by a plate

near the rear side of the appliance.

The manufacturer declines any responsibility for any damages caused by lack

of an effective ground installation.

For the electrical connection, hook-up, have available a wall circuit breaker

switch with multiple phase (see following list) with contact aperture distance,

equal to or not exceeding 3mm and a supply cable no less than 2.5mm².

Model

220/230V∼

220/230V3∼

380/400V 3N∼

FC54-E

20A

FC54-EA

For other supplies the cable cross section must be calculated according to

voltage and length of cabling. If cabling too long adjust cable size to Amp

rating; do not pull on supply cable or install it under tension. If cable needs to

be replaced use type H07RN-F.