Comco AccuFlo AF10-E 장비 매뉴얼 - 페이지 5

{카테고리_이름} Comco AccuFlo AF10-E에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comco AccuFlo AF10-E 14 페이지. Micro-abrasive blaster

AF10‐E Control Connector

Blast Control: Pin 1 provides 115VAC power from the AccuFlo. The host must provide a switch to put this

voltage back in to Pin 2, which will cause the blaster to blast. When Pin 2 is left floating, the blaster will not

blast. 200mA of current is typical.

PE: Pin 4 provides an optional bonding path to Primary Earth through the AccuFlo. If the host is otherwise

bonded to PE, do not use this pin.

Regulator Control: The regulator must be powered by 24vdc through Pin 7 and ground through Pin 6. The

regulator requires 60mA of current. The blast pressure is set by providing a 0‐10vdc signal at Pin 8, which

corresponds to a pressure of 0‐148psi. The internal resistance of the regulator's input is 100ohms minimum.

AF10‐E Cables and Controllers

Cabling and control depends on how the user desires to control the AF10‐E. Use the above table to

determine which cable to use. If the AF10‐E is paired with an AutoFill unit, refer to the AutoFill manual for

additional wiring information.

Tech Support: 1‐818‐841‐5500