Follett Symphony Plus 12CI425A 설치 매뉴얼 - 페이지 6
{카테고리_이름} Follett Symphony Plus 12CI425A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Symphony Plus 12CI425A 17 페이지. Ice and water dispensers
페이지 인쇄
Installing wall mount dispensers
§ WALL PREPARATION: Wall and fasteners must be of sufficient strength to carry weight of unit (185 lb (83.9 kg).
Hardware for this is not included.
Notes:
§ SensorSAFE™ infrared dispensing is standard.
1. Recommended minimum counter depth and mounting height (Fig. 6) ensures that ice will drop into sink.
2. See Fig. 6 for model dimensions. The dimensions include the 0.5" (13 mm) mounting bracket supplied with the
unit.
3. Cut utility hole in wall as shown (Fig. 5).
4. Mount support bracket to wall using fasteners of sufficient strength (fasteners not included, see Fig. 4).
5. Rough in water and drain lines (3/4" copper recommended for drain) (Fig. 9).
6. Lift dispenser onto support bracket, positioning unit so that hook on back of dispenser is captured by support
bracket angle (Fig. 6).
7. Install two (2) supplied 3/8"-16UNC screws through bottom of support bracket into bottom of dispenser (Fig. 4).
Slotted holes in support bracket allow you to adjust and level the dispenser. Ensure that the top of dispenser is
level or tilted slightly back toward the wall.
8. Remove bottom cover and make final connections (Fig. 7).
9. Attach bottom panel and hardware to bottom of dispenser (Fig. 8).
10. Clean dispenser prior to use.
Fig. 4 – Wall mount bracket and fastener requirements
wall mounting bracket
= Customer supplied.
6
12CI425A, 12HI425A
support bracket
screw
CAUTION!