Follett 18690 설치, 운영 및 서비스 매뉴얼 - 페이지 4
{카테고리_이름} Follett 18690에 대한 설치, 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett 18690 19 페이지. High-performance compact refrigerators
Installation ––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Installing Foot Pads - Required
CAUTION!
Use caution when tipping the refrigerator during foot pad installation. DO NOT EXCEED 30° angle.
Tipping more than 30° can result in compressor malfunction.
1. Remove the foot pads (4) from the plastic bag packed inside the
refrigerator.
2. Carefully tip the refrigerator back, ensuring that it can not fall, to
expose the four foot pad holes (Fig. 1).
3. Position the foot pad over the foot pad hole and press the
center of the foot pad until it is fully seated. The foot pads
extend 1/8" (3.2 mm) below the base of the refrigerator (Fig. 1).
Installing Shelves - Required
1. Remove shelves and shelf brackets packed inside refrigerator.
(If ordered, fi nd additional shelf accessory in separate box.)
2. Install shelf brackets in pilasters (insert top tab, squeeze and
push in lower tab) (Fig. 2).
Installing Glycerine Solution in Product Simulation Bottle - Required
1. Remove the 60 ml bottle from the bracket located in the upper left corner of the refrigerator.
2. Remove the top and fi ll the bottle with a 50/50 solution of glycerine and water.
3. Replace the top (and probe).
4. Reinsert bottle into the bracket.
Note: The probe monitors product temperature and must be installed for proper display and alarming.
4
REF1/REF2 Compact Refrigerators
Fig. 1
Fig. 2