Follett REF Series 설치 및 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Follett REF Series에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett REF Series 20 페이지. Undercounter refrigerator
Follett REF Series에 대해서도 마찬가지입니다: 설치 및 서비스 매뉴얼 (16 페이지)

페이지 인쇄

Service

Latch adjustment

To adjust for proper latch engagement

1. Loosen striker plate mounting screws (Fig. 11.1).

2. Move striker plate up or down as required and tighten screws.

3. Test operation of latch.

To adjust for proper gasket seal

1. Loosen striker depth adjustment screw (Fig. 11.2).

2. Adjust stop in or out and tighten screws.

3. Test operation of latch.

Door gasket replacement

1. Remove existing gasket from mounting track.

2. Verify mounting track is free of any remaining gasket material.

3. Align new gasket with mounting track and press firmly in place.

4. Open and close door, checking for proper gasket seal without

pinching against refrigerator.

5. Adjust latch and or striker as necessary for proper door closure.

Slide-out compressor tray

Follett's slide-out compressor tray allows technicians to partially

slide the condensing unit from the refrigerator back without cutting

refrigerant lines.

1. Remove rear panel (Fig. 12.1).

2. Remove two screws and spacers securing condensate pan, and

set pan aside (Fig. 12.2).

3. Remove two bolts securing condensing unit to refrigerator base

(Fig. 12.3).

4. Gently slide condensing unit out (Fig. 12.4).

Note: Do not put undue strain on the refrigerant lines.

Fig. 11

Fig. 12