Amprobe ACD-23SW 사용자 설명서 - 페이지 16

{카테고리_이름} Amprobe ACD-23SW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe ACD-23SW 20 페이지. Digital clamp meter

Non-Contact Voltage Indicator (NCV)

AC Volts: 70V to 600VAC (50Hz to 60 Hz)

Red LED and Audible Indicator

Battery Replacement

• Power is supplied by 1.5 volt battery x2 (LR03/SIZE AAA ).

• The "  " appears on the LCD display when replacement is needed.

• To replace the battery, remove the two screws from the back of the meter

and lift off the front case.

• Remove the battery from case bottom.

If there appears to be a malfunction during the operation of the meter, the

following steps should be performed in order to isolate the cause of the

problem.

1. Check the battery. Replace the battery immediately when the symbol

"  " appears on the LCD.

2. Review the operating instructions for possible mistakes in operating

procedure.

Except for the replacement of the battery, repair of the meter should be

performed only by a Factory Authorized Service Center or by other qualified

instrument service personnel. The front panel and case can be cleaned with a

mild solution of detergent and water. Apply sparingly with a soft cloth and allow

to dry completely before using. Do not use aromatic hydrocarbons or chlorinated

solvents for cleaning.