Comdel ESC-2/FP 운영자 매뉴얼 - 페이지 10
{카테고리_이름} Comdel ESC-2/FP에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comdel ESC-2/FP 17 페이지. Electrostatic voltage source
페이지 인쇄3.
The (PROMPT) response is defined as: <LF><CR> > or HEX A, D, & 3E
ESC-2 Serial Remote Commands
Instruction
! (NO <CR>)
SVxxxx
SIxxx
D+
D-
V+
V-
EV
DV
P+x.x
P-x.x
RV
RB
R+
R-
EE
DE
EX
# (NO <CR>)
To initialize serial communications a "!" character must first be transmitted to the ESC-2. The front panel will
display SR to indicate serial remote mode. An "H" character will display the HELP screen with all available
functions and commands.
NOTES:
1.
The minimum output default is 50Vdc. Settings of less than 0050 will yield 0Vdc. Voltage changes are in
1Vdc increments.
2.
The minimum current limit setting is 0.1mA.
3.
The minimum ramp settings are 0.1 seconds.
4.
Values less than 0.1 will default to 0.1 seconds.
8
System Specification
A. Output Capability
Description
True floating bi-polar output:
Output to input isolation:
Output voltage/current:
Output stability:
Output ripple:
Output linearity:
Output polarity reversal:
Output voltage balance:
B. Input Requirements
Single 24 Volt dc, 1 Adc (2 amp surge capability for 2 seconds at start up).
© 2006 Comdel, Inc.
Function
ATTENTION
SET OUTPUT VOLTAGE
(1)
SET CURRENT LIMIT
(2)
ENABLE AUTO DISCHARGE
DISABLE AUTO DISCHARGE
ENABLE AUTO VOLTAGE REVERSAL
DISABLE AUTO VOLTAGE REVERSAL
ENABLE VOLTAGE
DISABLE VOLTAGE
SET UPRAMP TIME
(3)
SET DOWNRAMP TIME
(4)
READ VOLTAGE
READ CENTER TAP VOLTAGE
READ POSITIVE CURRENT
READ NEGATIVE CURRENT
ENABLE ECHO
DISABLE ECHO
EXIT
EXIT
Specifications
Minimum path to chassis ground from any HV output terminal
>10 Meg ohm
> 500 Meg ohm (based on standard 5 KV dc hi-pot tests)
+/- 1000 VDC, 3mA maximum limit
0.1% or better of output from 0 to full load
Less than 0.2% at 50k Hz operating frequency
Better than 0.1% full scale
On command
Better than 0.5% for matched loads
ESC-2/FP Manual
Response
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
(PROMPT)
xxxx (PROMPT)
xSPxxx (PROMPT)
xxxx (PROMPT)
xxxx (PROMPT)
(PROMPT)
(PROMPT)
NONE
<CR><LF>BYE
7