Follett Symphony REF Series 설치, 운영 및 서비스 매뉴얼 - 페이지 11
{카테고리_이름} Follett Symphony REF Series에 대한 설치, 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Symphony REF Series 16 페이지. Undercounter refrigerator
페이지 인쇄
Temperature alarm
Before installing alarm
1. Remove supplied 9-volt back-up battery
from packing box.
2. Remove 2 screws from module face and
remove faceplate.
3. Install back-up battery on battery connector.
4. Locate DIP switches on the back of the
faceplate (Fig. 9).
5. Review the factory DIP switch settings
(Fig. 10) and make any changes required to
meet the needs of your specific application.
6. Reinstall faceplate.
Fig. 10
Dip Switch
OFF (factory default setting)
1
No alarm delay
2
Auto reset (alarm stops automatically as
soon as temperature returns to set range)
3 & 4
Audible alarm on
3
Enables 5 min alarm "snooze"
when reset button is pressed (with 4 on)
Installing alarm
1. Mount alarm in desired location with screws (supplied
by others) through back of housing. Do not place
undue strain on probe cable.
Note: Do not modify length of probe wire. Probe will not
measure temperature correctly if wire length is changed.
2. Plug power cord into 110 outlet.
3. Push center tab of short bottle bracket into top of rear left
pilaster (Fig. 11).
Note: Use longer bottle bracket for REF5 refrigerators
using cut-out upper shelf accessory.
4. Fill bottle with glycerin or other liquid to increase accuracy
of readings by simulating the internal temperature of
medications.
5. Insert bottle into bottle bracket.
Accessories
Fig. 9
ON
45 minute alarm delay
Manual reset of alarm (user must press
RESET button to stop audible alarm even if
temperature has returned to set range)
No audible alarm
Enables 45 min alarm "snooze"
when reset button is pressed (with 4 off)
Fig. 11
11