Amprobe CT-400 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Amprobe CT-400에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe CT-400 10 페이지. At-6000 series. advanced wire tracer

AT-6000 Advanced Wire Tracer Series - Quick Guide

Special Application: Finding Shorts

Set-up:

Transmitter

Verify the Loop

LED is ON.

1. Connect the Transmitter with the test leads

to the circuit.

2. Hold down the HIGH button for two seconds

to activate Loop mode.

Wire tracing mode:

Tracing a cable to find shorts

1. Start tracing the cable until the signal stops.

2. Verify the place of the fault: move the

Transmitter to the other end of the wire and

repeat tracing from the opposite end. If the

signal stops at the exact same location the

fault has been located.

AT-6000-T

TRANSMITTER

AT-6000-T

TRANSMITTER

Set-up:

Receiver

Precision

tracing mode

1. Turn on the Receiver

2. Press the MODE button to select a

wire tracing mode (either Quick Scan or

Precision Tracing).

Note:

This method will be affected

by signal cancellation effect. Expect

a relatively weak signal.

NCV