Amprobe LM-200LED 사용자 설명서 - 페이지 7
{카테고리_이름} Amprobe LM-200LED에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe LM-200LED 9 페이지. Led light meter
Amprobe LM-200LED에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (12 페이지)
페이지 인쇄
5. Press
6. Press
�
Always put the sensor protective cap back when the instrument is not
in use.
Lx / fc
Press
button to select the measurement unit.
1 foot-candle = 10.764 Lux and 1 Lux = 0.09290 foot-candle
Measurement Range
Press
button to select the measurement range. An "OL." Symbol on
display indicates over-range, select a higher range for measurement.
Maximum Hold
Press
button to obtain the maximum reading during measurement
(MAX symbol shows on display).
Press
button again to exit maximum hold mode (MAX symbol
disappears on display).
Data Hold
Press
button to freeze present reading on display (D-H symbol shows
on display).
Press
button again to resume measurement (D-H symbol disappears
on display).
Zero Adjustment
The instrument zero may change over time. To reset to zero follow the
instructions:
1. Make sure the sensor protective cap is fully covered on the sensor.
2. Set the range at the lowest LUX or FC range
3. Using a small flat screwdriver to adjust zero control (0 ADJ) until display
shows "0.00".
SPECIfICAtIoNS
general
Display:
Sensor:
Environment:
Altitude:
button to obtain the maximum reading during measurement.
button to freeze the present reading on the display.
2000 count LCD
Silicon photodiode and filter.
Indoor operation
Up to 2000m.
2