Amprobe NCV-1030 사용자 설명서 - 페이지 14

{카테고리_이름} Amprobe NCV-1030에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe NCV-1030 16 페이지. Ncv-1000, non-contact voltage probe

EMC

Compliance

Certifications

BATTERY REPLACEMENT & CARE

Low Battery Indication

The NCV-1030 and NCV-1040 Testers provide a low

battery indication in the form of a slowly blinking

red LED upon power on when battery level is low

and the batteries should be replaced. At that point

no voltage indication is possible.

The NCV-1020 does not provide the same

indication; instead, batteries will need to be

replaced when no LED appears upon power on.

Battery Replacement

To remove the battery cap, use the thumb grip to

pull it upwards and outwards. Remove batteries

and replace with (2) AAA 1.5 V alkaline batteries,

noting the battery orientation as shown on the

side of the tester. Replace the cap.

If the Tester will not be used for a long period

of time, remove the batteries.

Cleaning

The Tester can be cleaned with a mild solution of

soapy water. Apply sparingly with a soft cloth and

allow to dry completely before using. Do not use

aromatic hydrocarbons, gasoline, or chlorinated

solvents for cleaning.

IEC 61326-1

Korea (KCC): Class A Equipment

(Industrial Broadcasting &

Communication Equipment)

This product meets requirements

[1]

for industrial (Class A) electromagnetic

wave equipment and the seller or

user should take notice of it. This

equipment is intended for use in

business environments and is not to

be used in homes.



Latch

[1]

Battery Cap