Follett Chewblet 7 Series 설치 매뉴얼 - 페이지 10

{카테고리_이름} Follett Chewblet 7 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Chewblet 7 Series 20 페이지. Ice and water dispenser

Freestanding Installation

1. A clearance of at least 3" (7.6 cm) is required behind and on each

side of the dispenser for electrical connection and ventilation

(Fig. 4).

2. Rough-in the electrical service and water line.

§ Electrical: 115 V, single phase, 15A receptacle required. The dispenser

has an integral 8 ft (2.4 m) cord and plug.

§ Water: supply line (with shut-off valve) connects to the dispenser's

1/4" MPT inlet or John Guest push-in fitting.

3. If installing optional 6" Leg Accessory (item# 00956318), tilt or lay

base stand on side and screw each leg into stand (Fig. 8).

4. Remove four plastic, thread-protecting plugs from bottom of

dispenser.

5. Attach dispenser to base stand with supplied hardware (Fig. 5).

NOTICE!

If installing optional Drip Tray Drain Kit, refer to instructions

included with the Drip Tray Drain Kit.

Dispenser and Ice Machine - 115 V, 230 V, 220 V

Fig. 3

freestanding models

minimum 3" (7.6 cm)

clearance required

Fig. 4

Fig. 5