Amprobe WT-80 사용자 설명서 - 페이지 12

{카테고리_이름} Amprobe WT-80에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe WT-80 20 페이지. Orp meter

Setup

The advanced setup mode lets you customize your meter.

7 parameters are available in this model.

P2.0: Memory Clear

P3.0: Electrode data (invalid for ORP probe)

P4.0: PH buffer selection (invalid for ORP probe)

P5.0: READY indication

P6.0: Temperature unit

P7.0: Real time clock

P8.0: Reset

To enter SETUP mode, hold down "SET"key >1 second while in normal

measurement mode. Press "" or ""to select parameters and press"ENTER"

for parameter settings. To exit any setting, press "Esc" key.

Note: P1.0 memory transmitting function is not available in this model.

P2.0: MEMORY CLEAR(CLr)

To clear the stored data, press "MODE" key to select mV unit before

entering setup mode. While in setup mode, press "" key to select

memory clear function P2.0, "CLr" icon appears on LCD.(Fig.5)

Press "ENTER" key to enter P2.1.The default " NO" icon flashes on LCD.

Press "" key to change and then press "ENTER" key to confirm.

NOTE: This procedure will clear 99 memories at a time. Please consider

carefully before delete.

Fig. 5

P3.0: ELECTRODE (ELE) – invalid for ORP probe

This function is invalid in WT-70 with ORP probe.

P4.0: PH BUFFER (buF) – invalid for ORP probe

This function is invalid in WT-70 with ORP probe.