Advanced Amplifiers AA-28G-2KW-PT 사용자 설명서 - 페이지 11

{카테고리_이름} Advanced Amplifiers AA-28G-2KW-PT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced Amplifiers AA-28G-2KW-PT 13 페이지.

When the Main Control looses communication with RF Control or when it is not able to detect it after

being turned on.

When there is a uncorrectable error when reading microcontroller flash memory from a critical region.

When the TWTA is in this mode all the components, except the Main Control Board are disabled, to

protect from damage. Front panel display will be switched off and the external communication port

might be disabled (depends on the type of the communication port). To clear a Flashing Reset the

TWTA must be power-cycled. If the condition that caused the FLASHING RESET remains, the

amplifier will enter the FLASHING RESET mode again.

Gassy TWT:

If the TWTA has been inactive for several months the TWT may build up gasses. This allows the TWT

to arc internally and cause repeated TWTA faults.

To correct this condition, operate the TWTA for an extended period with no input pulses. When a fault

occurs, reset the TWTA and return to operate. A TWT that is recovering will be evidenced by a

widening period between faults. The length of time required will be determined by the particular TWT,

possibly up to twenty-four hours.

The TWTA should be operated periodically to prevent gassing.

Internal Pulse Generator:

The Internal Pulse Generator can be controlled remotely (Refer to the "10000 Series Communication

Protocol" document for more details) and from the Front Panel Display (see page 8).

Page 11 of 13