DPA 5100 사용자 설명서 - 페이지 7
{카테고리_이름} DPA 5100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DPA 5100 12 페이지. Mobile surround microphone
DPA 5100에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지)
페이지 인쇄
Specifications & Graphs for DPA 5100
CRITERIAS
Directional characteristics
Principle of operation
Cartridge type
Frequency range
Sensitivity, nominal ±3 dB at 1 kHz
Equivalent noise level, A-weighted
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL)
Total Harmonic Distortion (THD)
Dynamic range
Max. SPL, peak before clipping
Output impedance
Cable drive capability
Output balance principle
Common Mode Rejection Ratio (CMRR)
Power supply
Current consumption
Connector
Color
Dimensions
Weight
[LxWxH]
Capsule diameter
Cable (length/color/diameter/connector)
Maximum output voltage
Polarity
For L/R og LS/RS
Matching front/back
(frequency response and sensitivity)
LEFT, CENTER & RIGHT
Directional
DiPMic™ (Pressure, with interference tube)
and separation baffles
Pre-polarized condenser element
20 Hz - 20 kHz
200 Hz-16 kHz (±3 dB)
26 mV/Pa
Typ. 18 dB(A) (max. 21 dB(A))
Typ. 76 dB(A)
<1% up to 123 dB
103 dB
132 dB
50 Ohm
100 m (328 ft)
60 dB, 50 Hz - 20 kHz
Typ. 5 mA (max. 5.5 mA)
5.4 mm (0.2 in)
1.8 Vrms/2.5 Vpeak
Positive
All 3 microphones are factory selected to the
unit typical within 1 dB.
LEFT SURROUND & RIGHT SURROUND
Directional
Pressure, with separation baffles
Pre-polarized condenser element
20 Hz - 20 kHz
100 Hz-12 kHz (±3 dB)
28 mV/Pa
Typ. 20 dB(A) (max. 23 dB(A))
Typ. 74 dB(A)
<1% up to 123 dB
103 dB
132 dB
50 Ohm
100 m (328 ft)
60 dB, 50 Hz - 20 kHz
Typ. 5 mA (max. 5.5 mA)
5.4 mm (0.2 in)
1.8 Vrms/2.5 Vpeak
Positive
Both microphones are factory selected to the
unit typical within 1 dB.
7
LFE
Electronically derived
from L + R
20 Hz - 120 Hz (±3 dB)
100 dB
50 Ohm
100 m (328 ft)
60 dB, 50 Hz - 20 kHz
Typ. 5 mA (max. 5.5 mA)
195/240/140 mm (7.7/9.4/5.5 in)
5 m (16.4 ft)/black/9.3 mm (0.4 in)/XLR
1 Vrms/1.4 Vpeak
Positive
UNIT
3 / 2 / 1
Active signal balanced
Phantom power P48
Lemo multipin
Black
530 g (18.7 oz)