Amprobe 34XR-A 사용자 설명서 - 페이지 9

{카테고리_이름} Amprobe 34XR-A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe 34XR-A 19 페이지. Professional digital multimeter

Auto Power Off

Auto Power Off is a battery saving feature that puts the meter into a sleep mode if

the Function/Range Switch has not changed position in the last 30 minutes. To

wake the meter turn it off and then on.

The Auto Power Off feature can be disabled to keep the meter from going to sleep.

This feature is useful when using the MIN MAX mode for extended periods. To

disable the Auto Power Off feature use the following procedure:

1. Set the Function Switch to OFF.

2. Press and hold the MIN MAX button while turning the Function Switch to the

desired function.

3. Continue to press the MIN MAX button until the display finishes this

initialization period and the reading settles.

4. Release the MIN MAX button. The Auto Power Off feature will remain disabled

until the meter is turned off and then on.

The HOLD button causes the meter to capture and continuously display a

measurement reading. To use the HOLD feature make a measurement, and then,

after the reading has stabilized, momentarily press the HOLD button. You can

remove the test leads and the reading will remain on the display. Pressing the

HOLD button again releases the display.

Pressing the

button illuminates the display with a blue backlight. The backlight

will automatically turn off in about 60 seconds. Frequent use of the backlight will

decrease battery life.

Cleaning

To clean the meter, use a soft cloth moistened with water. To avoid damage to the

plastic components do not use benzene, alcohol, acetone, ether, paint thinner,

lacquer thinner, ketone or other solvents to clean the meter.

Troubleshooting

If the meter appears to operate improperly, check the following items first.

1. Review the operating instructions to ensure the meter is being used properly.

2. Inspect and test the continuity of the test leads.

3. Make sure the battery is in good condition. The low battery symbol B appears

when the battery falls below the level where accuracy is guaranteed. Replace a

low-battery immediately.

4. Check the condition of the fuses if the current ranges operate incorrectly.

XWWARNING

To avoid electrical shock remove the test leads from both the

meter and the test circuit before accessing the battery or the

fuses.

See Figure

-13-