Carbolite P1 사용 설명서 - 페이지 18

{카테고리_이름} Carbolite P1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carbolite P1 20 페이지. Type 3216

페이지 인쇄

Controller Fault

8 Controller Fault

8.1

Fault Code Diagnostic Table

Error Code Explanation

S.br

Temperature sensor failure

9 Glossary of Terms

Process Value (PV)

Setpoint (SP)

SP Ramp Rate

Control Setpoint

Element

Thermocouple

PID

Overtemperature (O/T)

Overtemperature

Protection

Ramp/Dwell Pairs

Program

Latched Alarm

Non-Latching Alarm

Power Cycling

The actual temperature of the furnace or oven.

The target temperature the furnace or oven is trying to

reach.

The speed at which the furnace or oven is allowed to

heat up or cool down.

The temperature that can be directly set into the

controller using the Up and Down keys

The heating device used in the furnace or oven.

The temperature-measuring device used in the furnace

or oven.

Proportional Integral Derivative: the control system used

by the controller.

The condition which a furnace or oven may enter if part

of the main control circuit fails.

A system to prevent the product or process being

damaged if it has gone into an overtemperature

condition.

A Program is split up into segments, each segment

Contains a Ramp and a dwell.

A sequence of stored Parameters set by the operator,

which will run automatically when started.

Will hold the alarm condition once it has been detected.

Will reset itself when the alarm condition is removed.

The Power to the controller is turned off and then back

on.

Actions

Replace the Furnace or Oven

Temperature Sensor

MC18-GB – v1.04

°C

°C/Min