Acer 7765PA - PalmPro XGA DLP Projector 운영 매뉴얼 - 페이지 13
{카테고리_이름} Acer 7765PA - PalmPro XGA DLP Projector에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer 7765PA - PalmPro XGA DLP Projector 35 페이지. Digital multimedia projector
Acer 7765PA - PalmPro XGA DLP Projector에 대해서도 마찬가지입니다: 운영 매뉴얼 (37 페이지)
페이지 인쇄
Operation
Turn On/Off Procedure
A
Power on
Press the Standby/On key to turn on the lamp. The LED will blink
green during warm up and then light solid green.
"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be
displayed on the screen after the projector has identified
the input signal;
"SEARCHING" message will be displayed on the screen if there
is no signal input;
"SYNC IS OUT OF RANGE" message will be displayed on the
screen
exceeds the range of the projector.
B
Standby
Press the Standby/On key for 2 seconds to turn off the lamp. The LED
will then blink orange and the lamp will shut down, but the fan will
continue to run for about 1 minute to cool the lamp. After the fan
stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again
while the LED is blinking, the projector will ignore the command
until it has cooled down for one minute.
if
the
horizontal
frequency
of
3
the
input
signal
English 9