Amprobe AM-42 사용자 설명서 - 페이지 4

{카테고리_이름} Amprobe AM-42에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe AM-42 9 페이지.

페이지 인쇄

-DCV & ACV functions (AM-42 only)

Rotate the rotary selector to the V position selects common impedance (Hi-Z) voltage measurements. DCV is the

default function. The DC annunciator "

" turns on. Press SELECT button momentarily to select ACV. The AC

annunciator "

" turns on.

-Resistance, Continuity, Diode & Capacitance functions (AM-42 only)

Rotate the rotary selector to the Ω/

position. Resistance "Ω"is the default function.

Press SELECT button momentarily selects Continuity function. The Audible annunciator "

" turns on. Continuity

is convenient for checking wiring connections and operation of switches. A continuous beep tone indicates a

complete circuit.

Press SELECT button momentarily AGAIN selects Diode test function. The annunciator "

" turns on. The

reading shows the approximate voltage drop across the test leads. Normal forward voltage drop (forward biased)

for a good silicon diode is between 0.400V to 0.900V. A reading higher than that indicates a leaky diode

(defective). A zero reading indicates a shorted diode (defective). An OL indicates an open diode (defective).

Reverse the test leads connections (reverse biased) across the diode. The digital display shows OL if the diode is

good. Any other readings indicate the diode is resistive or shorted (defective).

Press SELECT button momentarily AGAIN selects Capacitance function.

-Frequency function (AM-42 only)

Rotate the rotary selector to the Hz position selects Frequency function.

*Unlike the Line Level Hz Frequency function (for AM-47 only) as stated, this (Common) Hz Frequency function is

set only at the highest input sensitivity mainly for measuring small electronic signals of below 20VAC rms.

4-3) OTHER FEATURES

-Power On & Off

For models AM-47 and AM-45, press and hold the SELECT button for 1 second and then release to turn the

power ON or OFF. Press and hold the SELECT button for approximately 6 seconds to master reset the system to

the default stage if in case the meter hangs up unexpectedly.

For model AM-42, rotate the rotary selector to turn the power ON or OFF.

-Auto Power Off

Models AM-47 and AM-45 turn off after approximately 3 minutes of idle measurement readings and no

button/switch activities. Model AM-42 turns off automatically after approximately 30 minutes of no button/switch

activities.

-HOLD

and 30ms MAX

features (AM-42 only)

The Hold feature freezes the display for later viewing. Press the HOLD

(MAX ) button momentarily to activate

or to exit the Hold feature.

The Max feature captures voltage signals that have durations as short as 30ms (milliseconds) within a single

range, and has automatic up range capability. This mode is available in DCV & ACV functions. Press the HOLD

(MAX ) button for 1 second or more to activate or to exit the Max feature.

-Auto-ranging

If the function selected has more than one range, the meters will auto-range to the best range and resolution. No

manual ranging is required.

5) MAINTENANCE

WARNING

To avoid electrical shock, disconnect test leads from live circuits before opening the case. Do not operate with

open case.