Amprobe BT-120 사용자 설명서 - 페이지 7

{카테고리_이름} Amprobe BT-120에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe BT-120 10 페이지. Breaker tracer
Amprobe BT-120에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

OPERATION

Breaker and Fuse Identification

1. Plug the Transmitter into an energized wall outlet (Figure 1).

2. Make sure the red LED is ON to indicate that the outlet is energized.

3. Push the Power switch on the Receiver to turn it ON. The Receiver will

beep and the Power LED will be lit.

4. At the breaker panel or fuse box, hold the Receiver perpendicular to the

breakers. Scan slowly all breakers once to calibrate the Receiver. During

this scan, the Receiver may beep and flash at several breakers. This is a

normal part of the identification process (Figure 2).

5. Without touching the ON/OFF button, begin scanning again to identify

the right breaker or fuse. When the Receiver beeps, the correct breaker

has been identified.

6. Push and hold the Power switch for three seconds to turn the Receiver

off. Beeping and flashing during the shutdown is normal.

7. Unplug the Transmitter from the wall outlet.

.800.561.8187

Figure 1

Figure 2

www.

.com