DPCAV ShutterBug Pro 사용 설명서 - 페이지 10

{카테고리_이름} DPCAV ShutterBug Pro에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DPCAV ShutterBug Pro 16 페이지. Digital camera controller

Step 7:

This entry configures ShutterBug Pro for the type of external snapshot trigger you

need. For example, if you will be using it with an R/C receiver, press once for "R/C

Signal." To use the external switch method, press twice.

Important Note: Standalone mode users must set this feature to "R/C Signal."

NOTES ON SERVO POSITION PROGRAMMING (STEPS 8 - 10):

(1) During programming steps eight through ten, the Red LED will be on. This serves to warn you

that servo position programming is active. (2) If you are using the direct connect method these

steps can be ignored. (3) There are no time limits to setting the servo positions; a key press

selection must be made to continue to the next step. You may press twice to reload the factory

defaults or press three times to skip the entry with no change. (4) When setting the servo

position, the Red LED will urgently flash for several seconds if the R/C signal is missing. If this

occurs please check your R/C equipment and try again.

Step 8:

Neutral (Home) Servo Position

Range: 1= Store servo position, 2= Load factory default, 3= Skip (no change).

This entry allows you to precisely set the neutral (home) servo position. Use your

R/C transmitter (or servo signal simulator) to position the servo arm away from the

camera's shutter button. Once it is where you want it, enter one press.

Step 9:

Range: 1= Store servo position, 2= Load factory default, 3= Skip (no change).

This entry allows you to precisely set the Stage-1 (focus) and Wake-up servo

position. This is a half-pressed shutter button on cameras that support this. Use

your R/C transmitter (or servo signal simulator) to position the servo arm so that it

half-presses the shutter button. Once it is where you want it, enter one press.

Step 10:

Range: 1= Store servo position, 2= Load factory default, 3= Skip (no change).

This entry allows you to precisely set the Stage-2 (snapshot) servo position. Use

your R/C transmitter (or servo signal simulator) to position the servo arm so that it

GENTLY provides a fully depressed shutter button. Do not allow it to press too

hard or the servo will wear out very quickly. Once it is where you want it, enter one

press.

External Trigger Mode

Range: 1= R/C Signal, 2= External Switch.

Stage 1 (Focus) Servo Position

Stage 2 (Snapshot) Servo Position

Page 10

Sep-15-2013