DPCAV PANDORA 매뉴얼 - 페이지 3

{카테고리_이름} DPCAV PANDORA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPCAV PANDORA 7 페이지. Pan & tilt kit

Install the Hitec HS-81 servo's nylon cross-arm wheel onto the chassis. This requires four 2-56

x 3/16" machine screws, 2-56 nuts, the two Servo wheel back plates (items 7 & 8), and

Threadlocker. The servo wheel's four holes will need to be drilled out (.089" hole). If the

wheel's holes do not line up with the chassis's holes then rotate it 90 degrees. An ear on one

of the wheel back plates will need to be trimmed so that it does not interfere with the front

bulkhead.

Figure 5, HS-81 Wheel Top View

Using epoxy or solder, mount the tilt horn (item 13) to the tilt plate (item 9). Ensure that the two

parts are perpendicular and that the horn's tab is flush with the plate's slot.

(

), www.dpcav.com

ANDORA

REV-C

Figure 7, Tilt Horn mounts to the Tilt Plate

Figure 6, HS-81 Wheel Bottom View

Page 3