DPI INTELLIPHASE POWER 12-13D020T Series 사용 설명서 - 페이지 5

{카테고리_이름} DPI INTELLIPHASE POWER 12-13D020T Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DPI INTELLIPHASE POWER 12-13D020T Series 12 페이지. Dc-dc converters

페이지 인쇄

5.5. Ensure Vehicle Ignition Key is off and turn Battery Disconnect off so that the

Battery Pack is completely disconnected from Vehicle and loads. If a disconnect

switch is not available, disconnect Positive and Negative Cables from Battery

Pack. Confirm disconnection by checking with a voltmeter from frame to

positive and negative battery terminals. If not familiar with the use of

voltmeters: STOP Installation, and refer service to a Qualified Electrical

Technician.

5.6. Using a Voltmeter and Ohm-meter, check and verify all wiring connections in

accordance with Wiring Diagram Drawing used.

WARNING:

On cables constructed to run from Battery Positive (+) Terminal to the

Converter Positive (+) input, a Waterproof Automotive Grade in-line Fuse

holder must be installed within 6inches (15cm) from Battery Positive (+)

Terminal. On the cable constructed to run from the Converters High

Output Positive (+) terminal to the electrical load(s), install a Waterproof

and Automotive Grade in-line Fuse holder and place this fuse holder within

6inches (15cm) of the Converter Terminals Positive (+) output. For every

output circuit originating from the output of the Converter, the installer

must ensure that EACH CIRCUIT is fitted with its own Fuse where the

fuse is properly rated to protect the load that it services.

WARNING:

Holder Connect terminals must be BOTH crimped and

soldered to assure mechanical AND electrical bondage. 30 amp

currents are Welding Current Levels and improper

connections may result in heat points, fire and/or permanent

equipment / property damage and/or worse: personal injury.

CAUTION:

shorts, and wiring to wiring shorts. Also check all nut and bolt

fasteners (if any used) for tightness of connections and ensure

that these connections have been properly protected from

environmental exposure with the use of grease or similar

materials. Check and Confirm polarity of output wiring prior

to making any connections to electrical loads.

5.7. Ensure all electrical loads are disconnected from Converter's output. Enable

Battery Pack Disconnect Switch and/or reconnect Battery cables back to Battery

Pack Terminals to apply power to the converter.

PROPER FUSING MUST BE INSTALLED BY USER.

Wire connections to Connector Pins and Fuse

Using Ohm Meter, check for wiring to chassis