Amprobe ULD-400-R 사용자 설명서 - 페이지 14

{카테고리_이름} Amprobe ULD-400-R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe ULD-400-R 15 페이지. Ultrasonic leak detector

1.888.610.7664

5. MAINTENANCE

5.2 Changing the Transmitter Batteries

The ULD-400-T uses two 1.5 V AAA (LR03) batteries (supplied with ULD-420). To replace the

batteries, follow these steps:

1. Make sure that the Transmitter is turned off.

2. Loosen the battery-door lock with a flat screwdriver.

3. Remove the battery cover.

4. Replace the batteries as shown in Figure 5.2. Observe the battery polarity shown in the

battery compartment.

5. Replace the battery cover to the lock position.

Figure 5.2: Replacing the Transmitter batteries

The only maintenance the ULD-400 requires is inspection and cleaning. Periodically wipe the

exterior with a mild solution of detergent and water. Apply sparingly with a soft cloth and allow to

dry completely before using. Do not use aromatic hydrocarbons, gasoline or chlorinated solvents

for cleaning.

www.calcert.com