Carcomm Qtek 8010 설치 매뉴얼 - 페이지 2

{카테고리_이름} Carcomm Qtek 8010에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carcomm Qtek 8010 2 페이지. Mobile pda cradle

Mobile PDA Cradle

CMPC-32 HTC Typhoon / i-Mate Sp3 / Qtek 8010

Installing the Mobile PDA Cradle

1. Mount the window suction mount or Safety-Mount® (sold seperataly, instructions

included with the product ) To mount the window mount please clean the window and

place the window mount in your preferred position. Tighten the nut on the base of the

mount to make it stick to the window. Place the window mount in a position where it

doesn't interfere with the operation of the vehicle.

2. You can screw the cradle to your mounting part directly, or use the included swivel.

If you use a Safety-Mount® it may be necessary to drill holes in the Safety-Mount®

to be able to screw on the cradle with or without swivel. You can use the pattern on the

front page to see the positions where to drill the holes in the Safety-Mount®.

Adjust the swivel to optimize your view on the PDA screen and tighten it well.

3. Align the cradle on the rotating swivel or Safety-Mount® and screw the cradle onto it

with the enclosed screws through the 4 holes. Tighten the screws well.

For permanent installation and connection to the cars ignition power move on to step 5.

4. Plug the Cigarette jack into the Cigarette plug adaptor, check if the red light of the

cigarette plug is lighted. Now you are able to charge your PDA in the mobile cradle.

Move on to step 7.

5. Disassemble the Cigarette plug or cut it from the wiring loom and strip the wires.

(The cradle is also available with a fuse in the wiring loom instead of cigarette plug.)

6. Now the red wire (with fuse) needs to be connected to the red wire from the cradle

wiring loom. Then the other side of the fuse's wire needs to be connected to the

vehicle's 12V Ignition controlled voltage (+15) to avoid draining the vehicle's battery

when the vehicle is not used for a long time.

The black wire needs to be connected to the Negative Ground of the vehicle.

7. Slide the PDA into the cradle slowly and make sure the PDA is centred well

above the connector. Then press it over the connector gently.

When removing the PDA from the cradle use one hand to hold the cradle and other

hand to pull the PDA out of it.

Connecting a Carcomm Euro-Navigator GPS Receiver.

The phones supported by this cradle only support Bluetooth GPS Receivers.

When installing a Bluetooth GPS Receiver please follow the instructions supplied

with the product, phone and software to set it up.

Connecting the Carcomm CIGM-918 Quad-Band Inside-Glass Antenna. (optional)

Connect the FME Female plug from the CIGM-918 to the FME Female connector of the

Smartphone cradle. The Antenna should be mounted onto the vehicle's windscreen with

the VHB tape inside the vehicle.

(optional)

Step 1

Step 2

Step 3

Step 4

Step 7