DPM SATFINDER 매뉴얼 - 페이지 5

{카테고리_이름} DPM SATFINDER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPM SATFINDER 17 페이지. Sattelite finder meter
DPM SATFINDER에 대해서도 마찬가지입니다: 매뉴얼 (17 페이지)

Gwarancja

Warunki gwarancji zamieszczone są na stronie: http://www.dpm.eu/gwarancja

Safety instructions

1. User's manual is a part of the product and it should be stored with the device.

2. Before use read the user's manual and check the technical specification of the device and strictly

obey it.

3. Operating the unit contrary to the instruction manual and its purpose may cause damage to the unit,

fire, electric shock or other hazards to the user.

4. The manufacturer is not liable for any damages to persons or property caused by improper use,

contrary to its intended purpose, the technical specifications or the user's manual.

5. Before use check if the device or any of its components is not damaged. Do not use damaged

product.

6. Do not open, disassemble or modify the device. All repairs may only be made by an authorized

service center.

7. Use the device only in dry interior rooms. International Protection Rating for the device is IP20.

8. Do not use the detector immediately after it has been moved from cold to warm space. Wait until it

reaches room temperature.

9. The device should be protected against:

a. dropping and shaking

b. high and low temperatures

c. humidity, flooding and splashing

d. direct sunlight

e. chemicals

f. and other factors that could affect the device and its operation.

10. The device should be cleaned with a dry and soft cloth. Do not use abrasive powders, alcohol,

solvents, or other strong detergents.

11. Product is not a toy. The device and packaging must be kept out of the reach of children and animals.

Dial indicator  frequency range: 950-2150 MHz  power supply: DC 13-18 V  (10 x AA)  input level:

–40 dBm ~ –10 dBm  LNB gain: max. 60 dB  impedance: 75   F-connector  DC pass to LNB 

compass, coaxial cable, battery compartment (included)

User manual

1. Connect the LNB to the socket  using a coaxial cable with a F connector..

2. Connect the satellite tuner to the socket  using a coaxial cable with a F connector.

3. Turn on the tuner. The indicator  will be highlighted and indicate 0.



SATFINDER KIT

